SMT Corporation’s Electrical Test Lab can perform ISO 17025 accredited electrical testing as part of a component authentication process or as a stand-alone test service. Below is a summary of our capabilities and test equipment.

 

 A more detailed PDF is available for download at the following link

In-House Design

  •        PCB/Hardware
  •        Software Development

Passive Components

  •        FrequencyRange: 10Hz to 120MHz
  •        Resistance, Capacitance, Inductance, Impedance, Q Factor.
  •        Surface Mount Fixtures: Chip (0201 to 1206), Tweezer (0402 and larger)
  •        Through Hole Fixtures (Alligator Clips, Radial Lead)

RF

  •        FrequencyRange: 300kHz to 13GHz Frequency Range 
  •        Device Examples:
    1.     MMICs, Power Amplifiers, Filters, Multiplexers, Quadrature Modulators

 Discrete Semiconductors

  •        3000V to 50A testing capability
  •        ~1pA current measurement capability
  •        DC and Pulse (300µs) capability
  •        Lecroy WavePro 7300 Oscilloscopes – 3GHz Bandwidth for timing measurements

  Environmental Testing

  •        Burn-in testing per MIL-STD-883 Test Method 1015 (Static and Dynamic)
  •        Temperature Cycling per MIL-STD-883 Test Method 1010

Memory Blank Checking and Programming

 Integrated Circuits (Small and Large Scale)

  •        National Instruments PXIe 6555/6556 – 200MHz up to 192 Channels
  •        National Instruments PXIe 4 Channel SMUs (±6V to ±24V, ±500mA to ±150mA)
  •        Lecroy WavePro 7300 Oscilloscopes – 3GHz Bandwidth for timing measurements
  •        Advantest V93000 – 1.6Gbs Data Rate, 512 Channels (Upgradable to 2048 Channels)
  •        Device Examples:
    1.     DRAM (SDRAM, DDR, DDR2, DDR3, DDR4)
    2.     Flash (NOR, NAND, SPI, I2C, PROM, EPROM)
    3.     SRAM
    4.     FPGAs
    5.     Microprocessors
    6.     Microcontrollers
    7.     5962 Microcircuits
    8.     Logic
    9.     Analog (Multiplexers, Op Amps, Voltage Regulators, ADC/DAC, ect)